Difference between revisions of "Installing OpenPilot on the EON"

From comma wiki
Jump to: navigation, search
m
Line 15: Line 15:
 
See [[Installing Giraffe]] and [[Installing EON]] for information on installing the hardware into your car
 
See [[Installing Giraffe]] and [[Installing EON]] for information on installing the hardware into your car
 
See [[Configuring OpenPilot]] for information on how to get OpenPilot talking to your car.
 
See [[Configuring OpenPilot]] for information on how to get OpenPilot talking to your car.
 +
 +
See [[First OpenPilot Drive]] for next steps.
  
 
Visit #openpilot on comma.slack.com and say hello
 
Visit #openpilot on comma.slack.com and say hello

Revision as of 19:06, 19 December 2017

This page is for informational purposes only.

  • To install OpenPilot, reboot the EON and hold the volume down and the power buttons.
  • The phone should show the comma logo and boot into the cyanogenmod recovery screen.
  • Click "factory reset" then "full factory reset" and confirm.
  • Power off the phone and boot it back up
  • After you reboot, configure networking (either with SIM or WiFi)
  • NEOS will ask for an install URL; enter http://openpilot.comma.ai
  • The phone will begin the installation which will reboot and take 30 to 60 minutes, depending on network speed.
    • Don't worry if the screen is black for a long time, or has the loading spinner for a long time. Just be patient.
    • However, if the EON boots and does not have network access, it can and does hang indefinitely until the network comes back!

Congratulations, you have OpenPilot on your EON!

See Installing Giraffe and Installing EON for information on installing the hardware into your car See Configuring OpenPilot for information on how to get OpenPilot talking to your car.

See First OpenPilot Drive for next steps.

Visit #openpilot on comma.slack.com and say hello