Installing EON

From comma wiki
Revision as of 02:08, 27 December 2018 by VanillaGorillaa (talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

For installation in a Honda, see this tutorial video to find out correct placement and installation with a panda and giraffe.

For installation in a Toyota, see this instruction video.

  1. Mount the EON adapter.
    1. Horizontal aim - The inner edge of the fan (the side closest to the heatsink) should be directly underneath the stock LKAS camera. Overall aim may appear a little left of center, but post-Flippening code takes that into account.
    2. Vertical aim - The horizon should be at or just a little above center
    3. If you are installing with the Giraffe and Panda, install the Giraffe and Panda first and ensure that the USB can reach the Panda
    4. The previous preferred mount was to remove the mirror and mount the EON/NEO directly to the mirror mount. However, EONs come with the sticky GoPro mount. The instructions below will give you a good chance of installing a windshield mount level and straight:
    5. Experiments have revealed that the most important mounting aspect is the rotation (or roll) of the windshield mount. This method has repeatedly worked well:
      1. Park between two street lines (for instance: inside the yellow turn lane on a low-traffic street) Then put the car in drive with the parking brake on, and foot on the brake.
      2. Adjust the lanes until they look centered on the EON.
      3. Rotate the EON until the path line is perfectly vertical between the lines.
    6. If you prefer a Mirror Mount, here is a 3d printable STL file for a Honda Rearview Mirror Mount to GoPro adapter (may fit other cars too)

Consider following the Gridded UI wiki for precise EON placement.

Next, see Running ChffrPlus on the EON or Installing OpenPilot on the EON